#1,Start with a perfectly square sheet of paper made specifically for origami can be found at most craft stores. It is usually colored only on one side. I used a sheet that was colored on both sides.
#2, Begin by folding one edge to meet other,with the colored side outward...
...to get this.
#3, Open up the paper and lay it flat. Now repeat step 2 in the other direction, and open up it corner to corner...
#4, Fold it diagonally with the white side out (pink here). Line it up corner to corner...
...to get this.
#5, Open up the paper,repeat step 4 in the other direction, and open up the paper again.
#6,Lay the paper with the white side up.(pink here)bring in the side corners,while bringing the corner down...
...like this...
...to get this.
#7, With the open side pointing towards the left in this picture,fold one corner of the square so that the edge is lined up with center line...
...to get this.
#8, Repeat step 7 with the other flap.
#9, Flip the paper over and repeat step 7 for the other two flaps.
#10, Fold the top flap down and crease hard...
...to get this.Now fold it the same way in the opposite direction.
#11, Open the one side and lay it flat.
#12, Lift the top flap on the open end (the lower end in this picture)and fold it upwards,bringing in the sides...
...Like this...
...and lay flat to get this.
#13, Flip the paper over and repeat step 11&12 for the other side...
#14, With the open end toward the left, fold in one flap in so that the edge lines up with the center line...
...to get this.
#15, Repeat step 14 for the other flap.
#16, Flip the paper over and repeat step 14&15 for the flaps on the other side,like this...
#17, Fold over one side, like this...
...and lay flat to get this
#18, Fold up the top flap on the open end,so that the tip of the lower flap reaches the tip of upper flap...
...like this.
#19, Fold two of the flaps over and repeat step 18 for the lower flap.
#20, Fold one flap over and lay flat...
...to get this.
#21, Fold the top flap down...
...to get this.
#22, Flip the paper over and repeat step 21 for the other side.
#23, Invert fold one of the upper tips like this...
...to form the head.
#24 Pull back the other tip like this.
...to form the tail.
#25, Gently pull the wings apart to form the body.
and we are done!